Model No.: CT-10490
Shaping Mode: Injection Mould
Surface Finish Process: Polishing
Mould Cavity: Single Cavity
Plastic Material: PE
Process Combination Type: Single-Process Mode
Runner: Hot Runner
Design Software: Pro-E
Certification: TS16949, CE, ISO
Packaging: Wooden box
Productivity: 500000shots/mold life- 1000000
Place of Origin: China
Supply Ability: 10sets/month
HS Code: 8480790090
The front and rear bumpers of cars are made of plastic, known as plastic bumpers. The plastic bumper of a car is composed of outer plate, cushioning material and beam. The outer plate and cushioning material are made of plastic, the cross-beam is pressed with cold-rolled sheet to form U-shaped groove, and the outer plate and cushioning material are attached to the cross-beam.
Technical information for Car front bumer and rear bumper mould
Ceeto Service Scope to manufacture car bumper mould
Plastic car front bumper and rear bumper mould test
Before we ship bumper mould to you, we will have bumper mould buy-off in house together with you, and we must make official at least three mould tryouts and 2000 empty cycle for mould to check if mould function is ok in a certain time.
Normally, you and we attend the validation procedure together and sign off after checking. What we are checking usually are as follows:
Plastic car bumper mould material and heat treatment
What we will also inspect mould material and heart treatment as follows:
We warmly welcome you to visit us and send us RFQ, we want to be your part of suppliers and we will do our utmost efforts to make high quality of moulds and products, if you have any doubts about technical points, please don't hesitate to let us know, we are looking forward to hearing from you, thanks a lot.